Max-Flow 03

[Bazza]

Hi, just a quick one today,

Does anyone know of a possible reason why I am unable to adjust the output pressure on my 03 max-flo?

Can't raise it more than 600. Its been running smoothly for a couple years now and I maintain it reasonably well. I normally run it at around 900 (got the hp spring in it) for my mags but recently I cant get above the damn 600 mark.

This is off a fresh fill normally around 3-3500psi.

Any help greatly appreciated :thumbsup:

[Knackers]

How long since you pulled it to bits & maintained it?? I would start there new seals etc. It all else fails I can sell you one with a free xmag attached :clap: :thumbsup:

[Bigbird]

Bazza

Springs are like people. If you keep winding them up and backing them off they are going to get tired. The only reason i can think of if you maintain it well is that the main spring has got tired and just doesn't have the tension it once did. It may just need a new spring.

ask us when you see me next and we'll have a look at it. :thumbsup:

[Bazza]

Yeah the thing is though it only cropped up at that last training B.B...Other than that she has always kept up at 900 odd without any "fiddling" by me :confused:

I think I will just gut it for fresh internals oh and knackers stop taunting me with that X-mag, you know my weakness :cry:

Cheers for the help fellas :thumbsup:

[vendetta6]

you might have a LP spring.

[Mike]

Put a parts kit through it........that should make it go like new again. Replaces the spring and all your seals..... :thumbsup:

[Bazza]

Haha nah its a HP spring, trust me :D

Dont have a new spring with my parts kit but its no drama now as I've put the reg on my Ion so the lesser pressure works a treat (albeit a ghetto fix).