Sonic AC's and spinning Hoppers

[CDG]

I don't think has been mentioned before or if it has, I wasn't paying attention (that happens a lot... :o )

Although it's not mentioned on the MacDev site, after a phone call to Dianne Wed I have found that the Sonic Claw made for the Cyborg fits on the 03 Sonic AC Cockers.

No more Spinning Hoppers (especially Eggs) or using electrical tape.... :clap: :clap: :clap:

Though this might be helpful info to some

Cheers
Chris

[Hideous]

Although it's not mentioned on the MacDev site, after a phone call to Dianne Wed I have found that the Sonic Claw made for the Cyborg fits on the 03 Sonic AC Cockers.
No more Spinning Hoppers (especially Eggs) or using electrical tape.... :clap: :clap: :clap:

You can't use a revie X with a claw immediately... be careful to remove the lip on the hopper neck... as when you tighten the claw it will break

[CDG]

You can't use a revie X with a claw immediately... be careful to remove the lip on the hopper neck... as when you tighten the claw it will break

Thanks dude... having only tried my Egg I hadn't realised that.

[Hideous]

Thanks dude... having only tried my Egg I hadn't realised that.

Deadbeat broke his claw and i bent mine that way./... if there isnt enough lenght in the hopper neck.,.. it will bend and snap , my new untouched backup Revie is the same ... 3 mm too short because of the lip

[CDG]

Deadbeat broke his claw and i bent mine that way./... if there isnt enough lenght in the hopper neck.,.. it will bend and snap , my new untouched backup Revie is the same ... 3 mm too short because of the lip

Bugger... I have cut down my Egg feed neck previously and it seemed to fit ok but it sounds like it could be a problem

[bunkerboy]

Yeah, coupla my guys cut down their TSA Backman hoppers, and buggered the bottom claw when they then put them in. Saved me from doing it after seeing that:o

[skip]

where can i find these spinning hoppers, will go with my spinning hub caps